MegaPulse Surge Test Equipment for GR-1089 Issue 1 and 2,
Table 4-3, and Issue 3, Table 4-4, Second-Level Lightning Surge (Telecommunications Port)

The Surge Test described here requires an output voltage of 5000Vpeak. The waveform is the same as our MegaPulse 2x10s-2.5 used for the tests in Table 4-2, Surge 4, and the tests in Issue 1 and 2, Table 4-4, and Issue 3, Table 4-5. If any of these other tests are contemplated, the 2x10s-5 should be substituted. For a list of cross-references of GR-1089 tests to MegaPulse equipment, click here.

GR-1089, Issue 1 and 2, Table 4-3, and Issue 3, Table 4-4:

MegaPulse 2x10s-5 - Peak output voltage is adjustable up to 5000 volts minimum, peak short circuit current is 500A minimum. A switch is provided for reversal of output polarity. Optional divider network available for oscilloscope connection. Waveform generated is 2x10/2x10, V_p= 5000V. To perform the test, the front panel voltage meter is set to 5000V and the 10 ohm tap is used. Five output taps are provided so other tests in GR-1089 can be conducted. Z_out=2.5, 5, 8, 10 and 15 ohm.

Enclosure is 19 x 3U, rack mountable (3U enclosure)
Outputs are isolated.

MegaPulse 2x10s-5

Ships with cables, graphs of theoretical and actual waveforms.

Calibration Certificate

Options include relay outputs for PLC control.

Optional 1000:1 BNC Oscilloscope output allows quick connections and easy evaluation of output waveforms.

Two 1000:1 oscilloscope BNC jacks (differential mode only).

1 year warranty

This tester is configured with two outputs for testing two-wire products in accordance with Table 4-1 Test Condition B.

MegaPulse 2x10s-5-2

• Additional outputs for four-wire testing, as needed, up to four.

Options

Option RI: PLC Interface Relay Board.
Option BNCV: 1000:1 Voltage BNC output

    TOP