Defib-5 Pass-Fail
Defib-5
Defib Surge Tester
DF-1
DF-80
The MegaPulse 360J can be used to test products in research and production environments.
The biphasic output pulse mimics the newest defibrillator output standard but allows more repeatability and faster pulsing than a defibrillator would. The output is stable and provides the required 360J power in a production test or continuous test environment. The available autotrigger control provides very repeatable outputs which makes testing results more meaningful.
The MegaPulse 360J is used to prove any part which would be subjected to defibrillator pulses.
The biphasic output reversal timing can be configured at the factory for any timing desired within the pulse. Output power is also configurable upon request.
Output voltage is approximately 2kV, with slight variances to meet the 360J power requirement. Output may be as high as 2040V in order to provide the power required.
With the available 00-MPH Monophasic waveform option, the MegaPulse 360J can also
output the truncated isolation waveform of AAMI DF-1, Figure A.2 for additional testing of defibrillator leads.
The MegaPulse 360J can be used to test products in research and production environments.
TOPOption XIV: External mains interlock; disconnects primary side of power supply.
Option USB: USB Interface for control by Customer's LabView program.
Option TMM: TestMinder MegaPulse Computer Control w/ repetitive pulse capability.
Option RI: Relay isolated interface for PLC operation
Option MPH: Monophasic 200uF waveform addition, variable truncation time, with manual
internal resistor selection (10, 11, 12,., 20 ohms)
Option AT: Autotrigger when charge level reaches setpoint (requires option XIV)
Option P6015: High Accuracy Tektronix probe for proper waveform measurement
